The plant is capable to cut any materials even those are not laser-cuttable and stainless steels with thickness between 1,60 to 200 mm and dimensions up to 4000 x 2000 mm. Furthermore, the absence of heat affected zones permits high precision cuts with tolerances between 0,07 to 0,13 mm.


The plant is equipped with “Active Tolerance Control” which produces more accurate parts at significantly higher cutting speeds than conventional abrasive water-jet systems and often permits you to skip finishing steps.


This control compensates two classic typical negative phenomena affecting water-jet cutting systems that cause problems of precision and geometry errors: the jet lag and taper.


See our Machinery.

Contact us

to request information about our products and services
+39 0422 861190